NH  #4062
MA  # 13471
Master License
Fast reliable service
(978) 556-5617
(781) 581-0700
NH  #4062
MA  # 13471
Master License
Fast reliable service
(978) 556-5617
(781) 581-0700
Water Heaters
Pricing includes parts and labor. Please call to verify validity.
PHD reserves the right to change pricing/rates at our discretion.
Natural Gas Water Heaters (atmospheric/chimney vented)

• 30 gallon 6yr  = $1,540.00
• 30 gallon 10yr = $1,840.00
• 40 gallon 6yr  = $1,630.00
• 40 gallon 10yr = $1,860.00
• 50 gallon 6yr  = $1,825.00
• 50 gallon 10yr = $1,980.00
• 75 gallon 6yr  = $2,510.00
• 75 gallon 10yr = $2,745.00

LP-Propane Water Heaters (atmospheric/chimney vented)

• 30 gallon 6yr  = $1,750.00
• 30 gallon 10yr = $1,950.00
• 40 gallon 6yr  = $1,740.00
• 40 gallon 10yr = $1,920.00
• 50 gallon 6yr  = $1,940.00
• 50 gallon 10yr = $2,050.00
• 75 gallon 6yr  = $2,700.00
• 75 gallon 10yr = $3,050.00

Tankless Water Heaters

Navien NPE150S2
96% efficient, up to 120,000 BTU without recirculation pump - 15 year heat exchanger warranty.
On-Demand Up to 6.8 GPM = $5,300.00

Navien NPE180A2
96% efficient, up to 150,000 BTU with recirculation pump - 15 year heat exchanger warranty.
On-Demand Up to 8 GPM = $5,300.00

Navien NPE210A2
96% efficient, up to 180,000 BTU with recirculation pump - 15 year heat exchanger warranty.
On-Demand Up to 10 GPM = $5,600.00

Navien NPE240A2
96% efficient, up to 199,900 BTU with recirculation pump - 15 year heat exchanger warranty.
On-Demand Up to 11 GPM = $5,800.00

Rinnai RUCS75in
93% efficient, up to 160,000 BTU without recirculation pump - 12 year heat exchanger warranty.
On-Demand Up to 7.5 GPM = $5,200.00

Rinnai RUC80in
96% efficient, up to 152,000 BTU without recirculation pump - 12 year heat exchanger warranty.
On-Demand Up to 8 GPM = $5,400.00

Rinnai RUC98in
96% efficient, up to 199,000 BTU without recirculation pump - 12 year heat exchanger warranty.
On-Demand Up to 11 GPM = $5,500.00

Rinnai RUR98in
96% efficient, up to 199,000 BTU with recirculation pump - 12 year heat exchanger warranty.
On-Demand Up to 11 GPM = $7,000.00

Allowances have been made for condensate pump, piping and wiring on all above tankless units.

Power Vented Water Heaters
(nat gas - vent's direct to outdoors)

• 40 gallon 6yr = $2,400.00
• 50 gallon 6yr = $2,500.00
• 75 gallon 6yr = $3,400.00

Extended warranties are available for an additional cost, extending a 6 year warranty to 10 years.
Electric Water Heaters

• 30 gallon 6yr  = $1,530.00
• 30 gallon 10yr = $1,700.00
• 40 gallon 6yr  = $1,510.00
• 40 gallon 10yr = $1,700.00
• 50 gallon 6yr  = $1,620.00
• 50 gallon 10yr = $1,830.00
• 50 gallon Marathon -
Lifetime warranty = $2,400.00
• 80 gallon 6yr -
Light Commercial = $3,255.00
• 80 gallon HTP -
Lifetime warranty* = $3,050.00
.
Water heater pricing is based on removal and disposal of similar size and make as installed replacement.


Commercial Hot Water Heaters

Size and pricing available upon request.

High Efficient Heat Pump Water Heaters

• 50 gallon AeroTherm (heat pump) -10yr = $4,300.00
• 80 gallon AeroTherm (heat pump) -10yr = $4,900.00

Allowances have been made for condensate pump, piping and wiring. Additional costs may apply if existing electrical panel or wiring needs updating.
Bradford White Water Heaters
PLUMBING . HEATING . DRAIN CLEANING
rinnai tankless water heater
American Water Heaters
Combination Heat & Hot Water (Combi Boilers)

These systems are high efficient (95% AFUE) and in most cases wall hung.
Size and pricing available upon request.
Indirect Hot Water Heaters (lifetime warranty)

• SuperStor Ultra SSU 45 - 45 gallon = $4,150.00
• SuperStor Ultra SSU 60 - 60 gallon = $4,550.00
• SuperStor Ultra SSU 80 - 80 gallon = $4,880.00
• SuperStor Ultra SSU 119 - 119 gallon = $5,540.00


Price is based on installing tank up to five feet from boiler / furnace. Additional costs will apply for heating systems containing antifreeze & systems connected to steam boilers. Thermal expansion tank is not included (if required).
Water Heaters FAQ's (Frequently Asked Questions)

Q) Water Heater Size :- What size water heater do I need for my home.
A) Water heater size is determined by demand , usage and recovery. Please see below table for general sizing of tank type water heaters, while keeping in mind
that high capacity fixtures such as whirlpool tubs etc, need to be considered when making a decision about your next water heater.
The general rule for water heater recovery is - GAS = High efficient water heaters such as tankless or indirect water heaters will recover faster than power vented water heaters, where power vented water heaters will recover faster than atmospheric (chimney or gravity) vented water heater.
ELECTRIC = High efficient heat pump double phase 240VAC water heaters will recover faster than a single phase 120VAC water heater.

Q) Installing My Water Heater :-
Can anyone install a water heater.
A) There are many safety requirements and  local codes which pertain to water heaters, forgetting or eliminating a single safety mechanism on a water heater (electric or gas) could lead to catastrophic results. Many accidents have occurred in the past, so the quick answer is no, It is against the law for any unlicensed person to install plumbing fixtures in MA & NH.
Please take a couple minutes and watch my favorite twosome Adam & Jamie from the Discovery Channel with the repercussions of an incorrect installation.
Q) Water Heater Flooding :- How do I prevent flooding in my finished basement when my water heater fails ?
A) Water heaters generally last 6 to 15 years depending on the make, model, water pressure, usage and warrantee. A water heater usually never gives any warning of failure and some just crack open, spewing hundreds of gallons of water into your basement. The best prevention against water damage from water heater failure is the "FLOOD MASTER" device. Flood Master is a plug in solenoid device which is mounted on the water supply to your water heater. A sensor is placed either on the floor beside the water heater or in a pan under the water heater. Once water hits the sensor an alarm will sound and the solenoid valve will turn the water feed to the off position.

Q) Hot Water From Steam Boiler :-
I currently have a tankless water heater connected to my boiler which has failed. Do I have to replace the tankless coil, as my oil professional suggested, or do I have options ?
A) Tankless coils work well when new, but still supply a fluctuating temperature. Over time coils get clogged up with sediment or encrusted with minerals reducing the heat transference. Replacing the coil is one of a couple reliable options, depending on a variety of factors, another solution is installing a holding tank and feeding it with the existing tankless coil thereby having a larger volume of water at a constant, preset temperature. My personal favorite solution to this common problem, is installing an indirect water heater (Superstor, Amtrol etc) off the boiler with a separate loop. Recovery is super quick, especially in the winter when the boiler is at its peak performance.

Q) Water Heater Maintenance :- Should I have a maintenance plan for my water heater ?
A) Maintaining your water heater is a wise way of extending its life. Draining sediment from the bottom of the tank every couple years is a quick and easy form of maintenance,which most home owners can perform without the aid of a plumber, by simply attaching a hose to the bottom drain (spigot / faucet) of your water heater and, without turning off the water supply to the water heater, drain approximately three gallons of water from the hose. 
Changing the water heaters anode rod every four years is the best way of getting more life out of  the tank. Anode rod's are installed in water heaters to draw the corroding effect away from the steel tank and sacrificing itself instead. Below is a picture of two anode rod's. The significantly shorter rod on the left has been in service for three years, and as you can see is quite corroded compared to the new anode rod to the right. I would recommend having a licensed plumber for this project as it will effect the water heaters warranty and some water heater anode rods are connected to the plumbing, which would require cutting and soldering.


Brochures, Information & Manuals
phdplumbing@comcast.net
(978) 556-5617 or (781) 581-0700
(updated 04/01/2021)